Go on the wires in order so they're easier to reinstall into a new connector. Use your wire cutters to snip off the connector pin from the end of the wires. If you plan to replace the connector pins on multiple wires, push down on the pins individually and slide them out of the connector. Use body of controller as a fulcrum and lever the connector away from port.
7 Don’t push the wire so far that it’s sticking out of the other side of the connector pin. Push the wire into the pin until the end of the wire is even with the end of the pin. Take your wire and push the end of it into the connector pin being held by the crimper. Remove any additional wires that demand new pins. Seats the flat surface of the flathead onto the lip of the Molex connector. Slide the end of the wire into connector pin. Brand a clean cutting through the base of the connector pin to carve up information technology, and and so dispose of it in the garbage.
Have a pair of wire cutters or scissors and locate the base of the connector pivot on the cease of the wire. Take a picture of the connector before you remove the pins and then yous can reference it when you reinstall them.Ĭut off the quondam connector pin with wire cutters. The easiest way is to find a bit of tube thats a reasonably close fit to the pin (old car aerials etc are a good source) and slide it over compressing both. Notation: Information technology's important that you proceed track of the order of the wires as you remove them from the connector then you can reinstall them correctly. Brand sure you lot've got the pin pressed downward. If you lot're having trouble separating the wire, yous may not be holding the pin down to release it. This tool is the same as the professionals use to quickly and safely remove the electrical pins from Molex MX-150 style terminal connectors on these Harley-Davidson models: 2007-2010 Softail, 2007-2011 Dyna, 2007-2013 Sportster, 2007-2013 Electra Glide, Ultra Classic, Street Glide, Road Glide and Road King models.Slide the wire all of the fashion out of the connector. What I've done so far is: Disconnect the pin and socket halves of the Molex connector. Gently tug on the wire to separate information technology from the pivot. While you're holding downwards the pivot with 1 paw, use your other hand to catch the wire connected to the pin. Once the crimped wire has been inserted into the housing, it will be difficult to remove.
The power connectors have hooks that allow the connectors to latch into the connector housing. In my opinion the cheapest method to remove those difficult female molex connectors is using four thin straws which just slide over the pins. Pull on the wire continued to the pin to remove it. How do you remove a Molex connector To disconnect a Molex connector (male and female connection), simple press down on outside clip and pull the connectors apart.
0 kommentar(er)
